CANON PIXMA MP990 INK ABSORBER INSTALL

Step 3: Look for a black rubber frame under the cartridge assembly. Then wait for the cartridge to move out, and then unplug the printer’s power cable. Depending on your Canon printer model, this may be in the front or the back of the device. Step 1: Wear rubber gloves to ensure your hands do not stick ink, pour warm water into the bowl, get the dishwashing liquid ready. => Follow these steps sequentially to clean the waste ink absorber tray + Latex gloves – make sure your hands are not dirty Thinks and tools needed to clean Canon printer waste ink absorber: It should blink for two to three seconds, then stay lit this will indicate that the printer has been reset and is ready to print again without errors. Continue holding the power button down until the printer begins to reset itself and come online.ħ Wait for the green power light to turn off, then press and release the power button again. Replace the rubber frame in its original position and close the printer.Ħ Hold down the power button, then plug the printer back in. Carefully remove the ink absorber pad or pads from the rubber frame.ĥ Insert new ink absorber pads firmly into the rubber frame. They will likely be on the right side of your printer, and will be located underneath the area where the ink cartridges rest when the printer is in standby mode.ģ Use a paper napkin or other disposable and absorbent material to soak up any excess ink that may be in the pads by pressing it down onto the top of the frame.Ĥ Pull the rubber frame free from the printer, wearing gloves to keep your hands clean. Unplug the printer so that the cartridges will remain in their position.Ģ Locate the waste ink absorbers in their black rubber frame.

CANON PIXMA MP990 INK ABSORBER INSTALL

Open the printer as though you were going to install new ink cartridges, letting the cartridge cradle move to the center of the printing unit.

Canon pixma mp990 ink absorber